Posts Tagged ‘Air Conditioning’

Does Humid Air Affect How AC Runs? A Question From Marysville

Friday, September 9th, 2011

You’ve probably heard a dozen times in Marysville that humidity is removed by air conditioning. Unfortunately, the common assumption is that there is no inherent cost in allowing humidity to persist in their home. But, did you know it costs significantly more to remove humidity from the air with air conditioning than with a dehumidifier? Here’s why.

Water Vapor in Your Air Conditioner

Consider the amount of energy it takes to raise the temperature of water by one degree – one BTU. However, to change water from liquid to steam, another 10 BTUs are required. So, imagine how much energy it takes to condense water vapor from the air (in the form of humidity) into a liquid. This is what your air conditioner does whenever it processes humid air. It takes about 1,050 BTUs to condense one pound of moisture in the air into liquid.

The cost of running your air conditioner strictly for dehumidification can be huge, especially considering the fact that humidity is heaviest in the morning and evening when you probably don’t need your air conditioner every day (at least not early and late in the summer). Imagine, the cost difference if you used a dehumidifier to remove 150 or more pounds of moisture per week and an air conditioner when needed just to remove 15-20.

Negative Impact on How it Runs

Another thing to consider is that humidity can actually put an extra burden on your air conditioner. While the system is designed to remove that liquid from the air and get rid of it through the cooling coil and condensate drain, every extra minute the system is running is a bigger burden on it. Of course it will do its job for a few years, but the extra running time will add up, not only on your electricity bill but eventually on the machine itself.

The added pressure will result in eventual breakdown of the system and a need for early replacement. The easiest solution is to purchase a dehumidifier. These run at a fraction of the energy level of a full AC system and work extremely well to remove humidity from your home. In fact, most air conditioners will only remove humidity after 20-30 minutes of continuous operation. For short cooling cycles, you may not even dehumidify the house. So a dehumidifier ensures higher levels of comfort all at a lower cost.

Tags: , , , , ,
Posted in Air Conditioning | Comments Off

What is R410A? A Question From Granite Falls

Wednesday, September 7th, 2011

If you’ve recently started researching a new air conditioner for your Granite Falls home, you may have run across “R410A” – a newer form of refrigerant increasingly being used in high end air conditioning equipment. What is R410A and why is it different from the existing refrigerant most air conditioners have?

Chemical Composition

R-410A is a composite of diflouromethane and pentafluoromethane. This mixture of R-32 and R-125 creates a new compound designed to be used in commercial and residential air conditioning devices. Sometimes referred to as Puron, Genetron and EcoFluor, R-410A is a more environmentally friendly approach to cooling than the existing coolant most air conditioners use – R-22.

To date, R-22 has been the refrigerant of choice for millions of devices. However, because R-22 will no longer be permitted in new devices starting in 2020, R-410A is growing in popularity rapidly and will soon become the standard refrigerant option in new devices.

Environmental Impact

Despite being very similar in chemical composition to other refrigerants like Freon and R-22, R-410A does not contribute to ozone depletion, a major step forward for air conditioning. However, it has as very similar global warming impact – producing nearly 1725% more damage than carbon dioxide. One of the factors that negates this high global warming risk is the fact that R-410A is being used in a more efficient manner than past refrigerants.

Choosing R-410A

You cannot simply replace the R-22 in your cooling system with R-410A. Because it requires higher pressure, the devices that run with R-410A must be built specifically for this refrigerant. As a result, many manufacturers are starting the transition to the new refrigerant now, in anticipation of the 2020 phase out date for R-22. If you are preparing to buy a new unit, keep this in mind. You can still buy R-22 devices, but they are not as environmentally friendly as this newer form of refrigerant.

Tags: , , , , ,
Posted in Air Conditioning | Comments Off

Is it Cost Effective to Use a Ceiling Fan and AC at the Same Time? Some Advice From Stanwood

Friday, August 19th, 2011

There are a lot of ways to keep your Stanwood house cool in the summer, and chances are you’ve incorporated more than one of them into your home already. For instance, ceiling fans are great and can really keep you comfortable in moderately hot weather. But when the heat and humidity really start to pick up during the dog days of August, you need something a little more powerful to take the edge off, and that’s usually some type of air conditioner.

One or the Other?

If you’re like most people, you switch off your ceiling fan when the AC comes on. After all, the air conditioner is powerful enough to cool the house on its own. So is it really worth it to expend energy running another, secondary cooling device?

In fact, it is. Ceiling fans in particular use very little energy. Yet they’re quite effective at making your home feel cool and comfortable. So there’s really no reason not to take advantage of their benefits while running your AC.

Cutting Costs

You might be surprised to learn that far from being a waste of energy, using your ceiling fan and AC at the same time can actually save you money. That’s because the cooling power of the fan allows you to turn up the thermostat on your AC unit a couple of degrees without compromising your comfort levels.

And turning up the thermostat on the AC just that small amount will translate into pretty substantial savings on your monthly energy bills. That savings will more than pay for the cost of running the ceiling fan, and you save money.

Better Air Circulation

Running the ceiling fan with the AC on or off is always helpful in terms of promoting good air circulation throughout your house. And the more air circulates, the more comfortable your indoor environment will be. Good air circulation is also important because it helps to minimize the number of air contaminants that build up inside.

More Efficient Heating

The benefits of ceiling fans don’t stop with cooling either. In fact, you can run them in reverse to help maintain even heating in the winter. Essentially, there are few investments you can make that will serve you better throughout the year than a ceiling fan regardless of the other home heating and cooling systems you have in place.

Tags: , , , , ,
Posted in Air Conditioning, Energy Savings | Comments Off

Is it Possible to Vent Hot Air from a Garage? A Question From Duvall

Wednesday, August 17th, 2011

If you have a garage in Duvall, you know how hot it can get in there on a warm summer day. In fact, the air in your garage is likely hotter and more humid than the air right outside. Of course, you may not spend a lot of time in your garage, so reducing the temperature in there might not be an immediate concern for you.

But just like heat buildup in your attic, higher temperatures in your garage can have negative effects on the temperature in the rest of your home. Heat seeping into the house from the garage will cause your air conditioning system to work harder to keep it comfortable indoors. And that’s going to cost you money.

Getting the Heat Out

For all of these reasons, it’s a good idea to reduce the temperature in your garage as soon as possible. Of course, if you’re actively working in the garage or right outside, you can always leave the door open. This allows an influx of fresh, cooler air to clear it out.

But that’s not really a practical solution when you’re not immediately on hand. After all, you can’t leave your garage door open indefinitely and as soon as you close it, the heat will start to build right back up again.

Vents and Fans

One thing we don’t want to forget is that heat rises. That means installing a vent and fan in the roof where the hottest air will be can help remove the majority of the excess heat building up in your garage. Just like an attic fan, this fan can be triggered to come on when the temperature inside the garage reaches a certain point. Usually, the fan comes on when the indoor temperature reaches a point that is likely higher than outside – 90 degrees F or higher.

The fan then draws hot air out through your vent, reducing the temperature inside the garage to equalize the outdoor temperature. This will be effective in and of itself, but if you want even better results, you can also install another vent towards the bottom of your garage door. That way, as the hot air is pulled out of the top of the garage, fresh air will be drawn in through the vent, providing a constant stream of cooler, fresh air and promoting healthy circulation within your garage.

For more energy saving tips, talk to your HVAC professional.

Tags: , , , ,
Posted in Air Conditioning | Comments Off

How Does Geothermal Energy Work? A Question From Preston

Friday, August 12th, 2011

Geothermal energy is energy extracted from the ground, Preston or anywhere. This energy is in the ground in the first place because the ground absorbs the heat coming from the sun. This heat is always there, even when it is very cold outside. In fact, even when the ground appears to be frozen, you can actually extract plenty of heat to keep your home nice and toasty.

While this may at first appear to defy logic, the way that geothermal energy can be used for heating your home is actually quite simple. A geothermal heating system typically consists of an indoor air handler with a fan, a series of air ducts for the heated air to travel through and a closed loop of pipe that extends into the ground below and around your home.

This closed loop of pipe is actually where the geothermal heat is collected. Some type of liquid, usually water or antifreeze, will be continuously run through this pipe loop. As the liquid passes through the area of pipe that is below ground, it will absorb the heat from the surrounding soil. Once the liquid makes it back up to the air handler, the heat is able to disperse, heating the air in the chamber.

This heated air is then circulated throughout your house through the ducts by a fan. After it has released its heat into the air in your home, the liquid will cycle back into the ground to absorb more. This allows a geothermal heating system to provide you with a constant supply of warm air.

Unlike a furnace, which mixes in blasts of very hot air with periods of inactivity to try and keep your house at a constant temperature, a geothermal heat pump is able to provide a more consistent flow of air that is just the right temperature to keep your home comfortable. This means that these types of heat pumps are running just about all of the time as opposed to furnaces, but they are designed to work this way and the constant operation does not cause any excessive wear and tear.

Another great benefit of geothermal heat pumps is that they are able to keep your house cool in the summer as well. Just as the ground is warmer than the air in the winter, it is also cooler in the summer. That means that heat removed from your indoor air can be transferred to the ground in the same way that it was transferred in during the winter.

Tags: , , ,
Posted in Air Conditioning | Comments Off

Check Out Our Blog for the Latest in HVAC Technology

Thursday, June 23rd, 2011

Be sure to bookmark the G & S Heating, Cooling & Electrical blog for updates on the latest advances in HVAC and Electrical technology.

We’ll feature money saving promotions here as well.

Call G & S Heating, Cooling & Electrical for all your Heating, Air Conditioning, Indoor Air Quality, Water Heater, Geothermal, and Electrical needs.

Tags: , ,
Posted in Uncategorized | Comments Off