Posts Tagged ‘Heating Maintenance’

The Hardest HVAC Maintenance: A Tip from Monroe

Friday, November 11th, 2011

Do you hate to work on your own mechanical equipment in your Monroe home, like furnaces and plumbing fixtures? You aren’t alone. Many people are not cut out to be do-it-yourselfers (DIYers). They prefer to hand off their maintenance and repair chores to qualified professional. That’s not a bad thing. But there are lots of DIYers who prefer to work on their own home repairs – and those are the people who aren’t afraid to take on the most challenging jobs.

If you are looking for good ideas on how to maintain your home’s heating and cooling (HVAC) system beyond the normal filter changeouts, here are some good things to check – things that will help with the overall performance of your HVAC system.

  1. Check the ventilation system. The ventilation carries conditioned air from a main source throughout your home.  It takes a little time and effort to check your ventilation system for things like cracks or leaks around joints, but it is an important maintenance task. You may even find separations between joints or holes caused by nails. A leaky ventilation system could be sending conditioned air into attics, walls, or crawlspaces and making your furnace work extra hard just to keep your living areas warm and comfortable. Take time to visually inspect as much of your ventilation system as possible – usually metal or flex duct – and repair using joint glue, metal filler, or duct tape.
  2. Inspect the insulation. Your heating system works in conjunction with the insulation in your home to provide comfort and warmth while saving you on high utility bills. A home that is poorly insulated or not insulated at all will cause a furnace to work harder and not only send utility bills higher, but increase the possibility of mechanical failure. Replacing or adding insulation in walls and crawlspaces is a relatively easy, yet time-consuming task. You can roll down or tack up fiber insulation or blow in insulation into walls. You can also seal up cracks on your home’s walls, roof, or foundation with a number of different products. Once again, your goal is to make your heating system work less and save you money.
  3. Check the visible components of the furnace. A build-up of dust and dirt can make the moving components of your furnace work even harder, such as the motors, fan belts, contactors, etc. If you live in an area where there is lots of dust and humidity or if your home has several occupants and/or animals, it is particularly important to check your system on a regular basis. This can be done by removing the access panels and taking a vacuum cleaner hose into as many areas as possible. A good, thorough vacuuming should produce immediate results and make your furnace run much more efficiently.

Try these three steps and you may not have to repeat them for another year or so – possibly not ever again while you live in your home.

Tags: , , , , , ,
Posted in Heating | Comments Off

HVAC Safety the Whole Family Should Know: Some Pointers from Seattle

Monday, November 7th, 2011

If you think the most important thing a heating and cooling (HVAC) system can do in your Seattle home is to provide indoor comfort, you are right. But there is another thing an HVAC system does that is very important and it affects your entire family. It provides a safe indoor environment, too.

Besides warmth in the winter, a finely-tuned HVAC system can clean and filter the air you breathe. That’s important to people who suffer from allergies and is especially important for minimizing the spread of germs that cause colds and the flu. The key phrase in this paragraph is finely-tuned. If your HVAC system is not working correctly – out of tune – it can cost you a great deal in monthly utility bills and can be harmful to your health.

It is important for you and your family members to understand the basics of HVAC system maintenance so you can all understand the symptoms of improper maintenance and its consequences. For example, if anyone in your home is suffering from flu-like symptoms or are constantly drowsy or listless, they may be suffering from the a silent killer: poisonous carbon monoxide gas. This gas is formed during incomplete combustion of fossil oils like natural or propane gas. A malfunctioning furnace can emit carbon monoxide gases and you may never even realize it, until it is too late. Long-term exposure to the gas can cause brain damage and/or chronic sleepiness. It some cases, it can even cause death.

You may be able to diagnose the problem, but you aren’t qualified to test and repair a furnace that is creating deadly carbon monoxide gas. Your best bet is to call a qualified HVAC contractor who can diagnose the furnace and offer repair or replacement suggestions. But there are things you can do to prevent the build-up of carbon monoxide gas.

Check all exhaust vents, like chimneys and flues for any blockages. A blocked or partially blocked vent can cause the build-up of carbon monoxide gas. And never, EVER, use a gas or propane powered heater in an unvented area of your home. These types of heaters create various levels of carbon monoxide gas that needs to be circulated out of each room and replaced with clean, fresh air. So, your family can actively ensure that there is no debris, bird’s nests, animals, leaves, or snow in the ventilation system.

You can also “help” your HVAC system by keeping vents clean by vacuuming dirty vent grilles and, in general, keeping the home clean. The cleaner the home, the easier it is for your furnace to do its job and the easier it will be for you and your family will breathe. These are a few easy maintenance tips will keep you and your family warm – and safe – this fall and winter.

Tags: , , , , , , ,
Posted in Heating | Comments Off

Happy Halloween!

Monday, October 31st, 2011

Happy Halloween! Candy and costumes make any day fun; we hope you have a fantastic time trick or treating! Remember to be safe this holiday, and don’t forget it is time to start thinking seriously about fall maintenance for inside and outside your house. A quick tune up of your heating system will save you some trouble during this upcoming holiday season!

Tags: , ,
Posted in Holiday | Comments Off

Five Important HVAC Maintenance Tips from North Seattle

Monday, October 24th, 2011

Do you have a “mental checklist” of chores that need to be done a regular basis around your North Seattle home, such as cleaning the window treatments, washing windows, shampooing rugs, etc.? There are various areas of your home that need regular maintenance and cleaning – and that list includes your heating and cooling (HVAC) equipment. Do you know a poorly operating furnace can cost you in increased energy usage and higher utility bills? That same poorly operating furnace can be discharging harmful carbon monoxide gas into your home, creating a health risk.

So, it is important to keep your furnace in peak operating condition and the best way to do that is by making a checklist of HVAC maintenance tasks. Let’s look at five of them.

Check your filters. Routine replacement of your furnace filters should be every 1-3 months, depending on the indoor air quality of your home, number of occupants, size, etc. You can purchase disposable filters online, at a local “big box’ retailer, or from your local HVAC contractor. A visual inspection of your filter is the best way to determine if it needs replacing. If you have a removable electronic filter, it should be cleaned every few months using soapy water and a hose. Any restrictions to air flow through the filters can lead to poor indoor air quality and will cause your furnace to work even harder to circulate warm air through your duct system.

  1. Clean and insect the blower assembly and motor. You can do this with a vacuum. Also check the fan belt to make sure it is not too loose or if it has any cracks or splits.
  2. Look for any obstructions in vents and returns. Believe it or not, your furnace needs “help” to operate. Any build-up of dirt or debris around the grilles of your ventilation system will just make your furnace work a lot harder. Do a visual check inside and outside and pay special attention to flues and chimneys, where indoor air is exhausted. Any blockage can result in an accumulation of poisonous carbon monoxide gas.
  3. Keep the area clean and clear around your furnace and water heater. Never store flammable liquids near your heating equipment. Your furnace room is not a storage closet.
  4. Revisit your home’s insulation. When was the last time you checked out the insulation in your attic or crawlspace? Is it securely in place or drooping down? Are there bald spots where the insulation has deteriorated? Is the insulation sufficient or should it be upgrade?

Tips 1 and 2 relate directly to furnace maintenance but tips 3 to 5 are equally important, having a direct bearing on how your furnace performs and its ultimate efficiency. If you follow all five tips and have an annual inspection from a qualified HVAC contractor, you should enjoy a fall season of comfort, warmth, and safety.

Tags: , , , , , ,
Posted in Heating | Comments Off

How to Get My Furnace Ready for Winter: A Guide from Preston

Monday, October 17th, 2011

Being cold in the winter is normal – as long as you are outside. But you shouldn’t be cold inside your Preston home. If that happens, the first place to look to is your furnace, which may not be working correctly. Furnaces are like any other piece of mechanical equipment. They need to be maintained and serviced on a regular basis to ensure they are working at peak efficiency and warming your entire home at your desired comfort level.

The best time to get your furnace ready for winter is not during the cold winter months – it is before the winter season even begins. There are several way to get your furnace ready for winter and let’s explore some of them.

First of all, check and see when you last had your furnace serviced. If it has been over one year ago, you should schedule and maintenance inspection from your local qualified heating and cooling professional. And when you make that appointment, ask about service agreements and getting on a regular maintenance schedule. Most heating and cooling contractors offer service agreement plans which include furnace and air conditioning check-ups on an annual basis.

Okay, so you know who to call for maintenance but what can you do yourself? First of all, give your furnace a little “help” by checking the vents and returns throughout the house. Ensure that there are no obstructions or blockages such as rugs, clothing, furniture, etc. You need to have unobstructed paths for your heated and return air to flow. The more congested the path, the harder your furnace will have to work. And while you’re at it, make sure your vents are open or closed, depending on how much you use your rooms. For example, if you have an extra bedroom that doesn’t need to be heated, closed off the vent or close the damper in the ductwork. The heated air will be diverted to other parts of your home where it is needed.

You can also help the airflow by vacuuming the vent cover or removing it and vacuuming any of the ductwork that you can easily get to. For a more thorough job consider calling a qualified and professional duct cleaning contractor. Many heating and cooling contractors also offer duct cleaning service, too.

Another maintenance function that you can perform is cleaning or replacing the furnace filter. Depending on the size of your home and its air quality (occupants, pets, etc.), you may want to clean or replace your air filter every one to three months. A dirty filter can restrict airflow and can put contaminants like dirt and dust right back into your air system. If you don’t know how to replace your air filter, consult the furnace owner’s manual or go online to learn more. If your furnace uses an electrostatic air filter, it will need to be removed and cleaned, either by using a hose or with soapy water and a hose. Make sure you let it dry before re-installing it.

You may also want to inspect any electrical wires around your furnace to ensure none are broken or frayed. A visual inspection should be good enough.

Once you have done what you can, let your heating and cooling professional take over from there. They are licensed and trained to inspect your furnace and ensure that it is in peak operating condition. And do it today – while everyone else is waiting.

Tags: , , , , , ,
Posted in Heating | Comments Off

Maintenance Really Does Save Money: Some Pointers From Startup

Friday, September 16th, 2011

When it comes to your Startup home heating and cooling systems, you really cannot go wrong with proper annual maintenance. While it may seem like an unnecessary expense, especially if your systems are relatively new, you will save a lot in the long run if you pay that small fee once a year for each system.

During a maintenance visit, a technician can thoroughly clean out your heating or cooling system and check all parts to make sure they are not showing signs of excessive wear and tear. If they do find a problem or a part that needs to be replaced, they will be able to make the necessary repairs quickly and you will not have to worry about calling someone out later for an emergency visit.

Also, catching problems early like this means that repairs will likely involve fewer parts and cost much less than they would if you let the problem go and it became more widespread. The truth is that your heating or cooling system can continue to work when one or another of its parts is not working correctly, but that means that other parts of the system have to work overtime to create the same result.

Your heating or cooling system will also be much more energy efficient if it receives regular tune ups and attention from a professional. Even the best new systems lose a small percentage of their efficiency each year that they are in operation. While this is not much from year to year, the cumulative effect will soon cause your energy bills to climb higher than necessary.

Paying for regular maintenance, then, can actually save you money because it will mean you pay less each month to run your system. And it is never too late to start. Even if your heating or cooling system is not new, it will benefit from a thorough cleaning and tune up. You may be quite surprised how much your energy bills go down after this type of service has been performed.

Annual maintenance can also help you to get more for your money by extending the useful life of the heating or cooling system. Many systems that are properly maintained can last even beyond their expected life span, meaning that you will not have to replace it as soon as you would have otherwise. For all of these reasons, the minimal cost of an annual maintenance visit is well worth paying over the long term.

Tags: , , , , ,
Posted in Air Conditioning | Comments Off